GPS數據的處理方法在結構變形監測的應用_外文翻譯

摘要

全球定位系統(GPS)現在正積極應用靜態和動態位移法在有風的情況下對大型土木工程結構進行監測。然而,多路徑效應和低采樣頻率的精度影響GPS位移測量。另一方面,加速度計靜態和低頻不能有效的措施結構反應,但可以精確測量高頻結構的反應。因此,本文僅探討GPS與測量結合的可能性，信號提高對測量準確度的(靜態加上動態)一個結構的位移響應。集成數據處理技巧,利用兩個經驗?zāi)Ｊ椒纸?EMD)和自適應濾波的方法。一系列的運動模擬臺試驗，然后根據站點使用三個GPS接收器,一個加速度、“桌子”和一個運動仿真可以模擬各種類型的運動定義為輸入，在波時間歷程一個預先定義的靜態的位置。該數據處理技術應用：記錄的GPS和加速度計數據，發現兩者都有靜態和動態位移。這些結果通過實測位移運動產生運動仿真的“桌子”。比較結果表明,該技術能顯著提高測量準確度。

關鍵詞：GPS變形監測、結構、加速度計；綜合數據處理、靜態和動態位移法、EDM的經典分解模式；自適應濾波器


Abstract

Global Positioning System (GPS) is being actively applied tomeasure static and dynamic displacement responses of large civil engineering structures under winds. However, multipath effects and low sampling frequencies affect the accuracy of GPS for displacement measurement.On the other hand, accelerometers cannot reliably measure static and low-frequency structural responses, but can accurately measure highfrequency structural responses. Therefore, this paper explores the possibility of integrating GPS-measured signals with accelerometer-measured signals to enhance the measurement accuracy of total (static plus dynamic) displacement response of a structure. Integrated data processing techniques using both empirical mode decomposition (EMD) and an adaptive filter are presented. A series of motion simulation table tests are then performed at a site using three GPS receivers, one accelerometer, and one motion simulation table that can simulate various types of motion defined by input wave time histories around a pre-defined static position.The proposed data processing techniques are applied to the recorded GPS and accelerometer data to find both static and dynamic displacements. These results are compared with the actual displacement motions generated by the motion simulation table. The comparative results demonstrate that the proposed technique can significantly enhance the measurement accuracy of the total displacement of a structure.

Keywords：GPS structural deformation monitoring ・Accelerometer ・ Integrated data processing ・ Static and dynamic displacements ・ Empirical mode decomposition (EMD) ・ Adaptive filter